Futaba gyro gy520 manual

 · FUTABA GY Manuals. The gyro will repeat a ‘1 blink’. Move full left and full right and verify you do not hear the servo strain from binding. Watch the light on hy gyro, when you rotate the helicopter the light will blink fast either blue or red. If everything was okay then the light on the gyro will momentarily change to violet. GY Link GYLink software usage method Connecting the GY and PC 1. Select desktop lower left side "Start" button - "All Programs" - "Futaba" - "GY-Link", in that order. The GYLink software starts up. *If the following message appears, the CIU-2/CIU-3 is not properly connected to the PC. Recheck the connection and re-execute the program. Thank you for purchasing a GY AVCS gyro. Before using your new gyro, please read this instruction manual thoroughly and use the gyro properly and safely. After reading this manual, store it in a safe place. FOREWORD The GY is a small heading hold AVCS rate gyro for model he-licopters. Advanced tail control from electric helicopters to 90 size.

FUTABA GY Instruction Manual Page You should set it up in rate mode, even if you only intend to fly it in HH mode which most of us do. If you cannot stop the wagging, rotate the gyro 90 degrees. Do not tie the soft rubber line down to the helicopter, close to the gyro. Thank you so mannual. Futaba GY Gyro How-to. That is very helpful. developed for gyro use. •No part of this manual may be reproduced in any form without prior permission. •The contents of this manual are subject to change without prior notice. •This manual has been carefully written. Please write to Futaba if you feel that any corrections or clarifications should be made. Futaba GY The smallest, lightest and most advanced gyro in the world. GY Series technology revolutionized gyro performance in and the GY is doing it again today. Its cutting-edge MEMS (Micro ElectroMechanical System) sensor design, ultra high-speed processing speed and advanced PID control algorithm put it a quantum leap ahead of all.

Futaba GY User Manual. Snap the link on the servo and check that you do not get binding at full left and full right. On mznual helicopters the flybar can swing down low enough to reach a gyro mznual on the top of the framset. Move the Gear switch down position 1. The next second it will blink fast. Futaba GY User Manual. Loading WARNING! Failure to follow these safety precautions may result in severe injury to yourself and others. • Read through the entire manual before operating this product. • The GY requires seconds to initialize when the power is turned on. GY Link GYLink software usage method Connecting the GY and PC 1. Select desktop lower left side "Start" button - "All Programs" - "Futaba" - "GY-Link", in that order. The GYLink software starts up. *If the following message appears, the CIU-2 is not properly connected to the PC. Recheck the connection and re-execute the program.