Install furnace so all electrical components are protected from water. Level furnace from front to back and from left to right within 1/4 inch. Furnace must be installed level for proper condensate drainage. Furnace will not operate if condensate does not drain. When . ICP Furnace SUPREME FEMMBM-A Installation instructions and homeowner's manual (20 pages) 8. ICP SUPREME FEMMAM-A. ICP Furnace SUPREME FEMMAM-A Installation instructions and homeowner's manual (20 pages) 9. ICP AMPIE2. ICP Furnace AMPIE2 Installation instructions and homeowner's manual (64 pages) ICP BMF The (-)T/(-)(-)DSX series furnaces are design certified by CSA for use with natural and propane gases as follows: As a Category I furnace, it may be vented vertically with type B-1 vent pipe and also may be common vented as described in these instructions. This furnace should be installed in accordance with the American.
When moving or handling this furnace prior to installation, always leave the doors on the furnace to provide support and to prevent damage or warping of the cabinet. When lifting the furnace by the cabinet, support the ends of the furnace rather than lifting by the cabinet flanges at the return air openings (bottom or sides) or sup-ply air. • When the furnace is installed in non−direct vent applica-tions, do not block the furnace combustion air opening with clothing, boxes, doors, etc. Air is needed for proper combustion and safe unit operation. • When the furnace is installed in an attic or other insu-lated space, keep insulation away from the furnace. this furnace. Refer to the furnace rating plate or Section IV of these instructions. 2. Install this furnace only in a location and position as specified in SECTION I of these instructions. 3. A gas-fired furnace for installation in a residential garage must be installed as specified in SECTION I of these instructions. 4.
The installation manual for your Carrier gas furnace provide instruction regarding new system installation, and troubleshooting installation issues. Carrier 58CTA Installation Manual. Carrier 58CTW Installation Manual. Carrier 58CVA Installation Manual. Carrier 58DLA Installation Manual. A gas-fired furnace for installation in a residential garage must be installed as specified in the “Location Requirements” section of these instructions. The furnace is not to be used for temporary heating of buildings or structures under construction. The furnace shall be installed so the electrical components are protected from water. For installation in a residential garage, the furnace must be installed so that the burner(s) and the ignition source are located no less than 18 inches ( mm) above the floor. The furnace must be located or protected to avoid physical damage by vehicles. When a furnace is installed.
0コメント