Check manual feeder guides

2 Your WorkForce Pro WP Your WorkForce Pro WP After you set up your WorkForce® Pro WP (see the Start Here sheet), turn to this Quick Guide and your online User’s Guide for instructions on using your product. Note: Your product may look different from the illustrations in this guide, but the instructions are the same. Using the Control Panel. Open the tray, and adjust the paper guides; Adjust the rear paper guides; Load the tray; Using your printer. Loading tray 1. Open Tray 1, and adjust the paper guides; Extend the rear paper guides; Flex the sheets back and forth to loosen them; Load the paper; Loading the manual feeder. Load paper for single‑sided printing (simplex). User Guide LaserJet Pro MFP M, M www.doorway.ru www.doorway.ru 2 1 Mdw Mfdn Mfdw Mdw Mfdn Mfdw.

• Do NOT use this pet feeder with puppies, kittens, dogs or cats not able to reach the food tray or with any physical disability. • Do NOT use outdoors. FOR INDOOR HOUSEHOLD USE ONLY. Check operation frequently to be sure the pet feeder is dispensing properly. • For dry food use only. • DO NOT use wet, canned or moist food. This manual describes detailed instructions on the operation and notes about the use of this machine. To get maximum versatility from this machine all operators are requested to read this manual carefully and follow the instructions. Please keep this manual in a handy place near the machine. Power Source V, 50/60 Hz, 6 A or more. The Manual Feed message appears when Manual is chosen as the paper source in the printer driver and there is no paper in the manual feed slot. Check the solution applicable for your case. If you want to print from the manual feed slot, go to CASE A: Print from the Manual Feed Slot. If you do not want to print from the manual feed slot, go to CASE B: Print from the Paper Tray (Tray 1).

INSTALLATION, ASSEMBLY SETUP GUIDEs. Angled Tub Alley and Sweep. Bucket Rake. Cattle Handling Systems Diagrams. CattleMaster Open Sweep Alley System. CattleMaster Open and Sheeted Alley Sweep Systems. Cradle Bale Feeder Galvanized. Elite Dog Kennel. Finish Mower Operation and Assembly Manual. Galvanized Dog Kennel. Gate Hanging. Gate Rack. side of the feeder extension into the support notches until the plate snaps into place (Fig.8). The lock tabs should securely fit into the round holes and the short and long tabs should be fully inserted into the support notches (Fig.9). To remove, firmly grip the feeder extension and the extension plate and pull apart. Fig NOTE: The printed side will be the side which is face-up in the manual feeder. 2: Push the paper into the manual feed slot until a 'paper present' sensor triggers a feed roller. 3: Continue to apply just enough pressure to ensure that the paper is pulled in by the feed roller. 4: Adjust the paper width guides to correspond to the width of your paper. 5.